Resistive Forces & Terminal Velocity · Guide · glidepathscience.org
GuideResistive Forces & Terminal Velocity
Contents
This Guide explains the ideas and equations behind every Walkthrough step, Concept Challenge question and Predict round. Part 1 prepares the Intro track and Part 2 the Advanced track; each takes about ten minutes to read. Each section ends with a worked example that is not one of the sim’s own problems.
Part 1 · The essentials
Math you’ll need: algebra, square roots and unit conversions; one optional box uses a derivative.
Why falling things stop speeding up
Without air, every object near the ground falls with the same acceleration, $g$ = 9.81 m/s², and keeps speeding up as long as it falls. In air they do not: a raindrop falls at a few meters per second, and a skydiver lying flat levels off near 50 m/s. The difference is drag, the force a fluid exerts on a body moving through it. Drag grows with speed, so a falling body always reaches a speed at which the drag balances its weight. From then on the net force is zero and the speed stays the same: the terminal speed.
The forces on a falling body
Two forces act on a body falling through air: its weight $W = mg$, pulling down, and the drag $F_D$, pushing against its motion through the air, which for a falling body is up. At the instant of release the body is at rest, so there is no drag and it accelerates at $g$. As it speeds up the drag grows, the net force $mg − F_D$ shrinks, and so does the acceleration. Drag acts from the first moment of motion; it does not wait until the body stops speeding up.
This is why a steel ball beats a coffee filter. Both feel similar drag at the same speed, but the drag on the ball is tiny next to its 0.32 N weight, while the filter weighs only 0.0098 N and its drag soon matches that. Heavy, compact bodies are barely slowed; light, broad ones are slowed at once.
Terminal speed
For bodies the size of a ball or a person moving through air, the drag force is
$F_D = \tfrac12CρAv^2$
where $ρ$ is the density of the air (1.20 kg/m³ near the ground on a mild day), $A$ the area the body presents to the flow, $v$ its speed, and $C$ the drag coefficient, a number set by the body’s shape: about 0.45 for a sphere, 1.0 for a skydiver lying flat. At terminal speed the drag equals the weight, $F_D = mg$, and the net force is zero. This does not mean the drag is zero: drag and weight cancel. Setting $\tfrac12CρAv_T^2 = mg$ and solving,
$v_T = \sqrt{2mg/(ρCA)}$
What sets the terminal speed
The formula says how each property matters. More mass means more weight to balance, so a higher terminal speed, but only as the square root: four times the mass in the same shape falls twice as fast, because drag grows as $v^2$. More area or a blunter shape (larger $C$) means more drag at every speed, so a lower terminal speed. Thinner air, higher up, means less drag and a higher terminal speed. The height of the drop does not appear at all.
For spheres of the same material, mass grows as the diameter cubed and area as the diameter squared, so $m/A$ grows in proportion to the diameter and $v_T$ grows as its square root. That is why hailstones outrun raindrops.
The speed–time graph and fall times
On a graph of speed against time, a body dropped in air starts along the no-air line, with slope $g$, then curves over and flattens toward the dashed line at $v_T$, which it approaches but never crosses. The slope is the acceleration: it starts at $g$ and shrinks to zero.
A body that reaches its terminal speed early covers most of a long fall at that steady speed, so the fall takes about $t ≈ h/v_T$, much longer than the no-air time $\sqrt{2h/g}$.
The parachute
A parachute works by making $CA$ enormous. When a skydiver falling at about 51 m/s opens a canopy, the drag at that speed is suddenly many times the weight. The net force points up, so the diver slows down, while still moving down. As the speed drops, so does the drag, until it again equals the weight at the new, much lower terminal speed.
Part 2 · Going further
Math you’ll need: derivatives, separation of variables, exponentials, logarithms and hyperbolic functions. Every section below solves a first-order differential equation.
Linear drag, solved
Small, slow bodies in a sticky fluid feel drag in proportion to their speed. For a sphere of radius $r$ this is Stokes’ law, $F_s = 6πrηv$, with $η$ the viscosity; write it $F = bv$. With buoyancy, a falling sphere obeys (down positive) $m\,dv/dt = mg′ − bv$, where $g′ = g(1 − ρ_f/ρ_s)$. Separating variables, $dv/(v_T − v) = dt/τ$, and integrating from rest,
$v = v_T(1 − e^{−t/τ})$ $τ = m/b$
with $v_T = mg′/b$; for a sphere, $v_T = 2r^2(ρ_s − ρ_f)g/(9η)$. The speed reaches 63 % of $v_T$ at $t = τ$ and 95 % at $τ\ln 20 ≈ 3τ$. Because $τ = v_T/g′$, Stokes bodies, which are slow, get there almost at once.
Quadratic drag: the tanh solution
With quadratic drag, $F = cv^2$ with $c = \tfrac12CρA$ (many mechanics texts use $b$ and $c$ for the two laws’ constants). Down positive, $m\,dv/dt = mg − cv^2$, or $dv/dt = g(1 − v^2/v_T^2)$. Separating, $\int dv/(1 − v^2/v_T^2) = g\,dt$, so
$v = v_T\tanh(gt/v_T)$
from rest. Integrating again gives the distance fallen, $y = (v_T^2/g)\ln\cosh(gt/v_T)$; written with the speed instead of the time (using $a = v\,dv/dy$),
$y = −(v_T^2/2g)\ln(1 − v^2/v_T^2)$
The time scale is $v_T/g$ and the distance scale $v_T^2/g$: a body twice as fast takes twice as long, and four times as far, to get up to speed. A body thrown down faster than $v_T$ slows to it along $v = v_T\,\mathrm{coth}(gt/v_T + φ)$.
Which law? The Reynolds number
Which law applies depends on the Reynolds number, $Re = ρvD/η$, the ratio of the fluid’s inertia to its viscosity, with $D$ the body’s width. Below about 1, viscosity dominates and drag is linear: dust, cloud droplets, bacteria, beads in syrup. From about 10³ to 10⁵, the wake dominates and drag is close to quadratic with a nearly constant $C$: balls, raindrops, people. Between, neither law is exact. Near $Re$ ≈ 2–3 × 10⁵ a sphere’s $C$ drops sharply (the drag crisis), which this sim leaves out.
Up and down
Throw a ball straight up and drag adds to gravity on the way up (both point down) but opposes it on the way down. Up positive, the rise follows $dv/dt = −g(1 + v^2/v_T^2)$, which integrates to a tangent; the ball reaches
$H = (v_T^2/2g)\ln(1 + v_0^2/v_T^2)$
and falls back from there along the tanh law, arriving at
$v_f = v_0v_T/\sqrt{v_0^2 + v_T^2}$
which is less than both $v_0$ and $v_T$. The rise is quicker than the fall: going up the deceleration exceeds $g$, coming down the acceleration is less than $g$.
Energy and thin air
At terminal speed the kinetic energy is constant while the gravitational energy falls, so drag turns all of it into heat and moving air at the rate
$P = mgv_T$
The terminal speed also depends on the air. The standard atmosphere’s density falls from 1.225 kg/m³ at sea level to 0.819 kg/m³ at 4,000 m, and $v_T ∝ 1/\sqrt{ρ}$, so a diver who leaves the plane high up reaches a higher speed and then slows as the air thickens, while still "at terminal speed" at every moment.
Fitting the drag law
Nested coffee filters keep their shape, so a stack of $n$ has the same $C$ and $A$ but $n$ times the mass. If $v_T ∝ n^p$, the quadratic law predicts $p$ = ½ and the linear law $p$ = 1. Plotting $\ln v_T$ against $\ln n$ turns the power law into a straight line of slope $p$; plotting $v_T^2$ against $n$ gives a line through the origin whose slope $s = 2m_1g/(ρCA)$ yields $CA$. Each $v_T$ comes from a fit to the detector’s record: a straight line through the steady part (slightly low if the stack is still speeding up), or the full $\ln\cosh$ model.
Reference
Common mistakes
Part 1
- Thinking everything falls together in air. Only without air; drag separates heavy, compact bodies from light, broad ones.
- Thinking lighter bodies fall faster, or that heavier ones would fall faster even with no air.
- Drawing drag downward, or leaving it out until terminal speed. It points against the motion and grows from zero.
- Taking zero net force at terminal speed to mean zero drag. Drag equals the weight.
- Thinking four times the mass gives four times the terminal speed. It gives twice, since $v_T ∝ \sqrt{m}$.
- Thinking a parachutist moves up when the canopy opens. The net force is up; the motion is still down, slowing.
Part 2
- Using the exponential (linear-law) solution for quadratic drag, or tanh for Stokes drag.
- Using a sphere’s diameter for its radius in Stokes’ law, or leaving out buoyancy in a liquid.
- Expecting a thrown ball to come back at its launch speed, or the rise and fall to take equal times.
Equation sheet
| Part 1 | |
|---|---|
| Quadratic drag | $F_D = \tfrac12CρAv^2$ |
| At terminal speed | $F_D = mg$ |
| Terminal speed | $v_T = \sqrt{2mg/(ρCA)}$ |
| Below terminal speed | $a = g(1 − v^2/v_T^2)$ |
| A long fall | $t ≈ h/v_T$ |
| Stokes’ law | $F_s = 6πrηv$ |
| Part 2 | |
|---|---|
| Linear drag | $v = v_T(1 − e^{−t/τ})$, $τ = m/b$ |
| Stokes sphere | $v_T = 2r^2(ρ_s − ρ_f)g/(9η)$ |
| Quadratic drag | $v = v_T\tanh(gt/v_T)$ |
| Distance | $y = −(v_T^2/2g)\ln(1 − v^2/v_T^2)$ |
| Highest point | $H = (v_T^2/2g)\ln(1 + v_0^2/v_T^2)$ |
| Return speed | $v_f = v_0v_T/\sqrt{v_0^2 + v_T^2}$ |
| Power | $P = mgv_T$ |
| Reynolds number | $Re = ρvD/η$ |
$m$ mass; $g$ = 9.81 m/s²; $ρ$ the fluid’s density ($ρ_s$, $ρ_f$: the sphere’s and the fluid’s); $C$ drag coefficient; $A$ area facing the flow; $v_T$ terminal speed; $η$ viscosity; $r$ radius, $D$ width; $b$, $c$ the linear and quadratic drag constants; $τ$ time constant; $v_0$ launch speed.
Sources and further reading
OpenStax, University Physics Volume 1, Chapter 6, §6.4 “Drag Force and Terminal Speed” (CC BY-NC-SA 4.0, openstax.org), whose order of topics and notation the Intro track follows. The standard atmosphere’s density formula is the International Standard Atmosphere’s troposphere. The Field Manual (H) lists every value the sim uses and what its model leaves out.
Resistive Forces & Terminal Velocity v1.0 · © 2026 Dr. David Meier · CC BY-NC-SA 4.0 · glidepathscience.org