Potential Map · Guide · glidepathscience.org
GuidePotential Map
Contents
This Guide covers the ideas and equations behind every Walkthrough step, Concept Challenge question and Predict round. Read Part 1 before the Intro track and Part 2 before the Advanced track, about ten minutes each.
Part 1 · The essentials
The big idea
The electric potential V is a number at every point, measured in volts, and a map of it reads like a contour map of a hillside. Points at one potential join into equipotentials, the level lines. The electric field is the slope: it runs straight downhill, across the level lines, and it is strong where they crowd.
Potential, equipotentials and work
The potential difference between two points is the work per unit charge that the field does on a charge moved between them. For a charge q carried from A to B by any path:
$W_{field} = q(V_A − V_B)$ $ΔU = −W_{field}$
Only the ends matter: the field is conservative. Along an equipotential V never changes, so moving a charge along one, or around a closed loop, takes no work. A positive charge left to itself moves toward lower V and gains kinetic energy; a negative charge moves toward higher V.
The field is the slope
The field points in the direction V falls fastest, and its size is how fast it falls:
$\vec E = −∇V$ $|E| = |ΔV|/Δs$
The field crosses every equipotential at right angles: a part of E along an equipotential would do work along it, and none is done. It points toward lower potential. And with equipotentials drawn at equal steps of voltage, they crowd where the field is strong: the same ΔV over a shorter Δs. To measure a field, take two readings close together on either side of the point and divide the difference by the distance, in meters: volts per meter. The Lab Bench gives V/cm too, since its grid is in centimeters (1 V/cm = 100 V/m).
Adding potentials
A point charge q in space has potential $V = kq/r$ at distance r, with $k = 8.99 × 10^9$ N·m²/C², zero far away. For several charges the potentials add as signed numbers, and the fields add as arrows:
$V = \sum kq_i/r_i$ $\vec E = \sum \vec E_i$
Because one sum is of numbers and the other of arrows, either can vanish while the other does not. At the midpoint of a dipole, +q and −q, the potentials cancel (V = 0) while the fields point the same way. Between two equal positive charges the fields cancel (E = 0) while V is large. V = 0 does not mean E = 0, and E = 0 does not mean V = 0. Note too that V goes as 1/r, while the field goes as $1/r^2$.
Conductive paper and the mapping method
Conductive paper is a weakly conducting sheet. A supply holds metal electrodes at fixed voltages, a small current flows through the paper between them, and in the steady state no charge piles up anywhere. That single fact fixes V everywhere: it obeys Laplace’s equation, $∇^2V = 0$, between the electrodes, with the electrodes’ voltages at their edges and no current through the paper’s cut edge. A uniform sheet’s resistance cancels out: more resistive paper passes less current, but the map of V is the same, which is why cheap paper works.
To map it, clip the meter’s COM lead to the 0 V electrode and probe with the V lead. Chase a voltage, not a spacing: pick a value, find a point that reads it, then the next a little farther on, and join them. Draw the field lines last, at right angles to your equipotentials, from high V to low.
Conductors, hollows and points
Metal conducts millions of times better than the paper, so any difference of potential within it would drive a huge current until it vanished: a conductor is one equipotential, and two leads on the same electrode read 0 V between them. A hollow inside a conductor, with nothing in it, has its whole boundary at one V; the only solution of Laplace’s equation with that boundary is that same V everywhere inside, so E = 0 in the hollow. That is shielding. It does not make the field outside zero.
Equipotentials must wrap around a conductor, and around a sharp outside corner or a point they crowd: the field there is strongest, close in. A few millimeters out the effect fades. Charge collects where a surface curves most sharply, which is why Franklin made his lightning rods pointed.
How an ECG lead sees the heart
The body is a volume conductor, and the heart’s currents act, seen from a distance, like one current dipole p whose size and direction change through each beat. A lead reads the potential difference between its electrodes, which is p projected on the lead’s own axis: a lead looking along p sees a tall wave, one at right angles sees almost nothing. The limb leads are I = LA − RA, II = LL − RA and III = LL − LA, so at every instant
$II = I + III$
(Einthoven’s law). The electrodes can sit on the wrists and an ankle because no current flows along the limbs: a wrist is at its shoulder’s potential. Angles are clinical: 0° toward the patient’s left, +90° toward the feet. In Einthoven’s ideal triangle, lead I looks along 0°, II along +60° and III along +120°. The heart’s electrical axis is the main direction of p during the QRS: normally between about −30° and +90°. The lead with the tallest upright QRS lies closest to it, and the lead whose QRS is as far up as down (isoelectric) lies at right angles to it.
Part 2 · Going further
Laplace’s equation and its consequences
In the sheet, $\vec J = σ\vec E$ and, in the steady state, $∇·\vec J = 0$, so $∇·(σ∇V) = 0$. A uniform σ divides out, leaving $∇^2V = 0$; a σ that varies (ink, or uneven paper) does not, and changes the map. Two properties do most of the work:
- The mean-value property. V at any point of the open paper is the average of V on any circle around it, and, on a grid, close to the average of its four neighbors. So V has no maximum or minimum in the open paper: the extremes lie on the electrodes.
- Uniqueness. Once the electrodes’ voltages and the edges are fixed, there is only one solution. A hollow frame and a solid block of the same outline give identical maps outside, and a closed conductor decouples its inside from its outside exactly: a Faraday cage.
The flat world: ln r, currents and capacitance
Current leaving a small electrode on the sheet spreads over circles of circumference 2πr, so its field falls as 1/r and V as −ln r: the potential of a line charge seen end-on, not the 1/r of a point charge in space. For coaxial electrodes, a disc of radius a at $V_a$ inside a ring of inner radius b at 0 V:
$V(r) = V_a\ln(b/r)/\ln(b/a)$
A line charge λ gives $ΔV = (λ/2πε_0)\ln(r_2/r_1)$ between two radii. The supply current is Gauss’s law for the current density, $I = σ_s\oint \vec E·\hat n\,dl$ with $σ_s = 1/R_s$, which for the coax is
$I = 2πΔV/(R_s\ln(b/a))$
The same shape factor S sets the sheet’s conductance, $G = S/R_s$, and the capacitance per meter of long electrodes with that cross-section, $C′ = ε_0S$, so $G/C′ = σ_s/ε_0$: paper measures capacitance. For two parallel cylinders of radius a with axes d apart in open space, $C′ = πε_0/\operatorname{arccosh}(d/2a)$.
Curvature and corners
Two conductors joined by a wire share one potential. For spheres far apart, V = kQ/R and the surface field is E = V/R, so the smaller sphere takes the stronger field although the larger holds more charge: $E_s/E_b = R_b/R_s$. On a sheet the discs’ potentials go as ln r, which damps the effect: joined discs a distance D from ground give $(R_b/R_s)\ln(D/R_b)/\ln(D/R_s)$.
Near a corner of exterior angle β (the open angle around it), $V − V_0 ∝ r^{π/β}$, so
$E ∝ r^{π/β − 1}$
An outside corner (β > 180°) has a negative exponent, and the field grows without limit close in; an inside corner (β < 180°) has a positive one, and the field vanishes. Real corners are rounded, so the growth is cut off.
Floating conductors and cuts
A conductor connected to nothing carries no net current on the paper (no net charge in space); a round one in a uniform field floats at the applied value at its center. It pulls the field lines in: a long cylinder (a disc on the paper) has
$E_{pole} = 2E_0$
at its poles, and a sphere in space $3E_0$. A cut in the paper is the opposite boundary. No current crosses it, so the field has no part across its edge: equipotentials meet it at right angles, field lines run along it, about $2E_0$ at its sides and zero in front and behind. At a metal edge the field has no part along it: contours run parallel to it and lines end on it.
Images: two discs from two line charges
The equipotentials of two equal and opposite line charges are circles (Apollonius circles), each with its center outside the charge it surrounds. So outside two equal discs of radius R, centered ±D from their midpoint and held at +V and −V in open space, the potential is exactly that of two line charges at
$d = \sqrt{D^2 − R^2}$
from the midpoint: a little closer together than the centers. On the bounded sheet the match is approximate. The Sandbox’s “Same layout, other model” compares the two.
The electrical axis and lead fields
In Einthoven’s triangle a limb lead reads p’s projection on its axis, and an augmented lead (one electrode against the mean of the other two) √3/2 of it. With lead I along 0° and aVF along +90°, $\text{I} = p\cos θ$ and $\text{aVF} = \tfrac{\sqrt3}{2}p\sin θ$, so the axis is
$θ = \operatorname{atan2}(2\,\text{aVF}/\sqrt3, \text{I})$
The axis this sim scores is the direction of the QRS’s integral vector, $\int p\,dt$.
Einthoven’s triangle is exact only for a centered dipole in a round, uniform torso. In general each lead has a lead vector, and by reciprocity it is the field the lead would make if current were driven through its own electrodes: it depends on where the heart sits and on the torso (Burger’s scalene triangle). II = I + III still holds exactly, because it is Kirchhoff’s voltage law around the three electrodes.
Reference
The rules of a true map
- Equipotentials never cross: a point has one potential.
- Field lines cross equipotentials at right angles and point toward lower V.
- Metal is one equipotential; a hollow inside it has no field; field lines end on it at right angles.
- At a cut, lines run along the edge and equipotentials meet it at right angles.
- Open paper has no peaks or pits: the extremes of V lie on the electrodes.
Common mistakes
- “Strong field where V is high.” The field is the slope of V, not its height.
- Dividing by centimeters. A field in V/m needs the distance in meters.
- Dropping a sign. Potentials add with their signs; $W = q(V_A − V_B)$ is start minus end.
- Using $kq/r^2$ for V. That is the field; V goes as $kq/r$.
- “Zero in the hollow, because it is empty.” The hollow sits at its conductor’s potential.
- “The paper’s resistance changes the map.” A uniform resistance cancels.
- Expecting 1/r on paper. The sheet is a 2-D world: −ln r.
- Forgetting √3/2. The augmented leads are smaller than the limb leads.
- Reading screen words into ECG angles. 0° is the patient’s left, +90° the feet.
Equation sheet
| Part 1 | |
|---|---|
| work | $W_{field} = q(V_A − V_B)$ |
| field | $\vec E = −∇V$, $|E| = |ΔV|/Δs$ |
| point charge | $V = kq/r$, $k = 8.99 × 10^9$ N·m²/C² |
| superposition | $V = \sum kq_i/r_i$ |
| paper | $∇^2V = 0$ between electrodes |
| conductor | one V; hollow: E = 0 |
| Einthoven | $II = I + III$ |
| Part 2 | |
|---|---|
| coax | $V(r) = V_a\ln(b/r)/\ln(b/a)$ |
| line charge | $ΔV = (λ/2πε_0)\ln(r_2/r_1)$ |
| supply current | $I = 2πΔV/(R_s\ln(b/a))$ |
| two cylinders | $C′ = πε_0/\operatorname{arccosh}(d/2a)$ |
| floating cylinder | $E_{pole} = 2E_0$ |
| corner | $E ∝ r^{π/β − 1}$ |
| images | $d = \sqrt{D^2 − R^2}$ |
| axis | $θ = \operatorname{atan2}(2\,\text{aVF}/\sqrt3, \text{I})$ |
Symbols: V potential (V) · E field (V/m) · q charge (C; nC = $10^{−9}$ C) · λ charge per length (C/m) · r, s distance (m) · k = 1/4πε₀ · $ε_0$ = 8.854 × 10⁻¹² F/m · $R_s$ sheet resistance (Ω per square) · $σ_s = 1/R_s$ · I current (A) · C′ capacitance per length (F/m) · β exterior angle · θ electrical axis (clinical degrees) · p the heart’s dipole.
Further reading
Samuel J. Ling, Jeff Sanny and William Moebs, University Physics Volume 2 (OpenStax, 2016), Chapter 7, Electric Potential; Paul Peter Urone and Roger Hinrichs, College Physics 2e (OpenStax, 2022), Chapter 19, and Section 20.7 on electrocardiograms: free online under CC BY-NC-SA 4.0. And this lab’s Field Manual (H): how the model works, and what it leaves out.
Potential Map v1.3 · © 2026 Dr. David Meier · CC BY-NC-SA 4.0 · glidepathscience.org